All the cables are cut to length, and terminated.
Tomorrow after class, it all gets assembled.
To do:
1) mount motor to adapter plate, key shaft.
2) mount this to transaxle spline, bolt in place
3) connect control cables to motor.
4) attach controller box somewhere
5) see about stabilizing motor to existing motor mount brackets...may need to fabricate this out of angle iron
6) SAFETY CHECK...connections, potential shorts, grounding, etc.
 |
| Why, that would just suck! |
Sheeeyit...if all goes well, this thing should be rolling under its own power by sundown tomorrow!
No comments:
Post a Comment